Статті КМТ
Permanent URI for this collection
ENG: Articles
Browse
Browsing Статті КМТ by Author "Andrieiev, Volodymyr S."
Now showing 1 - 5 of 5
Results Per Page
Sort Options
Item Comparative Analysis of Calculation Results of Supporting Structure of Soil-Cement Piles(Kaunas University of Technology, Kaunas, 2019) Pshinko, Oleksandr M.; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Hubar, Oleksіy V.; Ihnatenko, Dmytro Yu.; Markul, Ruslan V.ENG: Abstract. The article presents the results of comparison of the stress-strain state of 4 models of a retaining wall structure of soil-cement piles on a landslide-prone slope. This study compares the changes in the stress distribution and displacements in the model elements of the retaining structure of soil-cement piles depending on the design parameters and the method of piles location in the body of the soil mass. The comparison of models of supporting structures of soil-cement piles on a landslide-prone slope allowed obtaining: –the comparative analysis of the quality work of individual elements of the supporting structure for strength and deformation in a three-dimensional representation; –the comparative assessment of the performance of the supporting structure of soil-cement piles on a landslide-prone slope; – histograms of dependences of changes in the angle of piles inclination to the vertical axis of their holding force, strength and deformation of the slope;Item Comparative Analysis of the Parameters of the Strength of the Subgrade at the Transition to the Higher Axial Loading up to 25 t(IOP Publishing, Kharkiv, 2019) Radkevych, Anatolii V.; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Mukhina, NataliyaENG: Abstract. A review of the scientific and technical literature on the re-alignment of the route during the transition to high axial load from the accepted today (23.5 t / axis) to the perspective (25 t / axis) shows that in the stage of preliminary researches imitation modeling of the earth web by the finite element method (ITU) as the most convenient, accurate and illustrative of the known numerical methods. In order to provide recommendations on the strength of the subgrade when moving to a higher axial load up to 25 t / axis, an analysis was conducted, the essence of which was to compare the stress-strain state of the subgrade at two loads per axis: 23.5 t / axis (existing ) and 25 (perspective). All the geometric and deformation characteristics of the formation are taken from data on a two-track section with a height of embankment of 3. The deformation characteristics are chosen so that the working material of the formation is in accordance with the average indices of deformation capacity of the railways used. The ITU train load calculus makes it possible to obtain all the factors of VAT in it, which is the main purpose of the study of the strength of the earth cloth, and allows to forecast their development in the future.Item Improving the Safety of Railway Subgrade When it is Strengthened Using Soil-Cement Elements(Dnipro National University of Railway Transport named after Academician V. Lazaryan, 2019) Krysan, Vitalii; Krysan, Volodymyr; Petrenko, Volodymyr D.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.ENG: Abstract. The article identifies the main parameters of the drilling-mixing technology, which is the most effective in fixing weak soil bases during the construction and restoration of transport, industrial and civil structures. The difference of the technology developed by the authors is that the strengthening process is carried out at low pressure (0.15 ... 0.25 MPa). The relevance of the research is that the proposed technology requires less cost with high rates of restoring the strength of soil foundations. To prove the high quality of the technology, laboratory studies were carried out to determine the optimal characteristics of the soil-cement element, as well as the proportions and composition of the fixing solution. The dependences of the strength of soil-cement elements in the air-dry condition with cement content from 7% to 23% with water-cement ratio in solution 1 / 0.3 and with cement content from 13% to 37.5% with water-cement ratio in solution 1/0,6. During the experimental-industrial studies of the author's technology, the embankment was constructed with the soil-cement-reinforced elements for the access road approaches at one of the facilities in Kirovograd region, which ensured safety in the operation of a complex transport structure.Item Investigation of the Operation of the Railway Track with Reinforced Concrete Sleepers in Curved Sections with Radius R ≤ 350 m(Printing House “Technologija”, Kaunas, Lithuania, 2020) Markul, Ruslan V.; Hubar, Oleksіy V.; Arbuzov, Maxim; Andrieiev, Volodymyr S.; Tiutkin, Oleksii L.; Savyts’kyy, V.; Ganich, Ruslan Ph.ENG: The article presents the results of the research on polygon extension for laying reinforced concrete sleepers under difficult conditions (R≤350 m, mountainous terrain) with ensuring safety traffic and reliable operation of the railway track. Changes in the geometry of the track in the plane with wooden sleepers and Д0 fastener as well as reinforced concrete sleepers with СКД65-Б fastener in the curve with the radius of 350 m were investigated. The results of the research allowed to obtain: - method and algorithm for determining the tapping section of the track gauge extension on reinforced concrete sleepers in curves with radius R ≤ 350 m; - comparative assessment of the track gauge change with the use of Д0 fastener (wooden sleepers) and СКД65-Б fastener (reinforced concrete sleepers) in curves with a radius R ≤ 350 m; - factors impact on the track gauge extension under difficult operating conditions; - empirical dependence of the process of the track gauge width change and the frequency of its adjustment in the cases of СКД65-Б fastener (reinforced concrete sleepers) and Д0 fastener (wooden sleepers) use in curves with radius R ≤ 350 m; - conclusions on the probability and feasibility of concrete sleepers use under mountainous terrain conditions, including difficult operating conditions (R ≤ 350 m).Item Study of the Interaction of the Railway Track and the Rolling Stock Under Conditions of Accelerated Movement(IOP Publishing, 2020) Hubar, Oleksіy V.; Markul, Ruslan V.; Tiutkin, Oleksii L.; Andrieiev, Volodymyr S.; Arbuzov, Maxim; Kovalchuk, O.ENG: Comprehensive studies of the interaction of the railway track and the investigated rolling stock under accelerated conditions have been carried out. The basis of the research was to obtain and substantiate the process of stress state, force interaction of the railway track and the rolling stock under conditions of accelerated movement. Introduction of the new rolling stock into continuous operation is a serious task that must be solved comprehensively. The implementation of this direction significantly affects the reliability of the elements of the railway track. Within the framework of the research, the approach was used that takes into account theoretical and experimental parts of the research using the methodology of prof. O. P. Yershkov. As a result of the studies, average stress values were established: in rails, they variate within the range 44.37...70.99 MPa; in the sleeper, they reach 0.78 MPa; in the ballast layer, they have 0.13 MPa; in the body of the subgrade, they reach 0.04 MPa, which is significantly less than the maxima allowable values. While speed change from 140 to 160 km/h, the values of the studied parameters decrease: vertical force (9.39 %), lateral forces (19.79 %); stresses in the edge of the rail flange (15.86 %); stresses in the edge of the rail head (16.67 %); stresses in the neck of the rail (8.74 %). The obtained results made it possible to form trends and recommendations on the feasibility of further increasing speeds development. At the same time, this made it possible to substantiate in more detail the operation of the railway track in the case of accelerated movement.